XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Shim on roll center when roll https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=12701 |
Page 1 of 1 |
Author: | Ruben_qlc [ Thu Jun 28, 2012 00:15:30 ] |
Post subject: | Shim on roll center when roll |
Hello, I am thinking how to get more steering in the middle of the corner, when apply trotthle. When the car turn and roll, if I put more shims in the front roll center (the shims in the caster block), ¿the car get more turn in? If I do this in rear roll center I get more grip in the rear, correct? Thanks. |
Author: | Stanley Bąk [ Sat Jun 30, 2012 08:24:09 ] |
Post subject: | Re: Shim on roll center when roll |
if you want more steering in the corner you should give 0mm shims on front clamps and 1mm on rear put rear shocks one more upright(it will give also more turn in) and give 2mm shims under the steering block reduce shims on ackermann i had the same problem and it worked but i also angled the front arms(front front down,front rear up- 0,5mm) put in front gear diff 1mm on ackermann and after this i had to reduce steering from 100% to 65% hope it helps |
Author: | Ruben_qlc [ Sun Jul 29, 2012 22:11:00 ] |
Post subject: | Re: Shim on roll center when roll |
Thank you Stanley. |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |