XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
CASTOR https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=126 |
Page 1 of 1 |
Author: | MR JOLLY [ Mon Sep 20, 2004 15:37:31 ] |
Post subject: | CASTOR |
Author: | Tonyv [ Mon Sep 20, 2004 17:02:45 ] |
Post subject: | |
Author: | MR JOLLY [ Mon Sep 20, 2004 18:50:07 ] |
Post subject: | |
Author: | 1jag8 [ Tue Sep 21, 2004 17:24:05 ] |
Post subject: | |
Author: | Tonyv [ Tue Sep 21, 2004 22:55:17 ] |
Post subject: | |
Author: | MR JOLLY [ Wed Sep 22, 2004 09:26:22 ] |
Post subject: | |
tonyv So what srings would you start with outdoor,rubbers or indoor t27`s I will go out with light blue`s all round & go from there |
Author: | Tonyv [ Wed Sep 22, 2004 10:00:57 ] |
Post subject: | |
White or light blue all round are generally good staring points. |
Author: | MR JOLLY [ Sat Sep 25, 2004 19:15:39 ] |
Post subject: | |
Author: | Tonyv [ Sun Sep 26, 2004 21:31:08 ] |
Post subject: | |
Yes, assuming you have the FK bulkheads. With these you should have three holes to mount the front and rear pivot pin holder. This goes for both the front and rear bulkheads. Assuming you have the rear pivot in the bottom hole, the middle hole at the front will give a 1.5 degree angle and the upper hole 3 degrees. |
Author: | MR JOLLY [ Sun Sep 26, 2004 22:43:40 ] |
Post subject: | |
Thanks tonyv we are getting there ![]() Q)1, why did`nt x-ray mill out the rear of the xrc chassis to use the lower holes in the rear bulkheads(FK) ![]() Q) 2, since i can`t use the lower holes in the bulkhead, if i put a 1mm spacer under the rear ball joint on the rear hub,Is this a good subsitiute ![]() |
Author: | Tonyv [ Mon Sep 27, 2004 13:51:30 ] |
Post subject: | |
Author: | MR JOLLY [ Mon Sep 27, 2004 16:36:35 ] |
Post subject: | |
Author: | Tonyv [ Mon Sep 27, 2004 17:17:50 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |