XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
little problem with rear toe in... https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=12575 |
Page 1 of 1 |
Author: | roger999 [ Mon May 07, 2012 12:33:54 ] |
Post subject: | little problem with rear toe in... |
guy, any ideas what to do to have same toe in on rear left and right wheels? right hand side is 3 but left hand side is about 2.8..? i pushed the alu holders against tightening direction but still is not right.. First was 2.5 but now i could do it until 2.8 but still have no 3... |
Author: | Stanley Bąk [ Mon May 07, 2012 18:11:43 ] |
Post subject: | Re: little problem with rear toe in... |
possibilities: difrent hubs difrent shims(compering on rear rear blocks) tweaked main plate check it |
Author: | roger999 [ Mon May 07, 2012 18:46:48 ] |
Post subject: | Re: little problem with rear toe in... |
Author: | Stanley Bąk [ Mon May 07, 2012 19:53:51 ] |
Post subject: | Re: little problem with rear toe in... |
so then you have got sth wrong with your set up you've got Hudy's set up station? |
Author: | roger999 [ Tue May 08, 2012 13:32:52 ] |
Post subject: | Re: little problem with rear toe in... |
Author: | Peter Phillips [ Tue May 08, 2012 15:03:58 ] |
Post subject: | Re: little problem with rear toe in... |
Best solution ive found is the solid suspension block, as ran by Alex at ETS Poland. |
Author: | roger999 [ Tue May 08, 2012 15:52:23 ] |
Post subject: | Re: little problem with rear toe in... |
Author: | CharlesF [ Tue May 08, 2012 18:28:53 ] |
Post subject: | Re: little problem with rear toe in... |
I've found this on every XRay I've had too, but not the T3'12 that I have now - the LHS rear toe is slightly less than RHS (I checked it with a straight-edge too, as I suspected my setup station for a while) I just shimmed it to even it out (a 0.3mm shim usually works fine) |
Author: | roger999 [ Tue May 08, 2012 19:48:07 ] |
Post subject: | Re: little problem with rear toe in... |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |