| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| Need help with wheel hex https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=12570 |
Page 1 of 1 |
| Author: | nashies [ Fri May 04, 2012 22:33:01 ] |
| Post subject: | Need help with wheel hex |
I can't manage to take the wheel hex out of the car  it's stuck hardly on the drive shaft. I guess it may causes from that i never take it out since i built my T3 up 3 months ago and they all got dirt inside. Please give me some advice, I tried to loosen the screw on the hex but they screw heads all got loosed also.
|
|
| Author: | Stanley Bąk [ Fri May 04, 2012 22:38:54 ] |
| Post subject: | Re: Need help with wheel hex |
at first take HUDY's 1.5mm srewdrivier and try to unsrew it under angle if it wont work take screwdriver - and put it between the hex and the hub and just push it maybe it will came out i had the same and with this unsrewing with some angle it was fine remember, DO NOT overtighten those screws |
|
| Author: | Skiddins [ Sat May 05, 2012 00:39:18 ] |
| Post subject: | Re: Need help with wheel hex |
Try spraying some brake /motor cleaner into them to loosen them. There is also a spray in the uk called Plus Gas which is used to loosen rusted nuts and bolts etc. Might be worth trying to get hold of some. Skiddins |
|
| Author: | Hagberg [ Fri May 11, 2012 21:08:20 ] |
| Post subject: | Re: Need help with wheel hex |
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|