XRAY - Model racing cars

My config will be:
- SP 13.5t V3 (Nr. 138135V3)
- SP Cirtix
- CS LiPo 7,200mAh 295gr
- receiver RX-461 10gr
- lightweight body LTC-R
- servo Sanwa SDX-801 50gr
- tires Sorex 32R (mandatory for club racing also ETS)
- transponder (as usual)

Will I be able to meet the weight criterion of 1,350gr this way?! (including balancing weights)

Mine is similar and is just over 1350g without any weights at all

Now, the balancing theme surprises me. I run the T3R without the true LiPo conversion set from Xray or the Hudy blades for underneath the LiPo and I needed to add the weight of a 9V block to the LiPo's side. Without that weight the car had massive load change effects through medium fast to fast left-to-right chicanes but ran fine through right-to-left chicanes. Also during braking into left corners the rear was more stable than on braking into right corners. (The last point I didn't notice on carpet but at a nitro track.)