XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
T3'12 weight https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=12559 |
Page 1 of 1 |
Author: | Kensei [ Mon Apr 30, 2012 09:44:02 ] |
Post subject: | T3'12 weight |
My config will be: - SP 13.5t V3 (Nr. 138135V3) - SP Cirtix - CS LiPo 7,200mAh 295gr - receiver RX-461 10gr - lightweight body LTC-R - servo Sanwa SDX-801 50gr - tires Sorex 32R (mandatory for club racing also ETS) - transponder (as usual) Will I be able to meet the weight criterion of 1,350gr this way?! (including balancing weights) |
Author: | Skiddins [ Mon Apr 30, 2012 11:35:38 ] |
Post subject: | Re: T3'12 weight |
Mine is similar and is just over 1350g without any weights at all |
Author: | Kensei [ Mon Apr 30, 2012 17:47:29 ] |
Post subject: | Re: T3'12 weight |
Author: | Skiddins [ Mon Apr 30, 2012 22:28:10 ] |
Post subject: | Re: T3'12 weight |
Author: | Hagberg [ Tue May 01, 2012 22:50:48 ] |
Post subject: | Re: T3'12 weight |
Author: | Green Wing [ Thu May 03, 2012 13:18:49 ] |
Post subject: | Re: T3'12 weight |
Now, the balancing theme surprises me. I run the T3R without the true LiPo conversion set from Xray or the Hudy blades for underneath the LiPo and I needed to add the weight of a 9V block to the LiPo's side. Without that weight the car had massive load change effects through medium fast to fast left-to-right chicanes but ran fine through right-to-left chicanes. Also during braking into left corners the rear was more stable than on braking into right corners. (The last point I didn't notice on carpet but at a nitro track.) |
Author: | Skiddins [ Thu May 03, 2012 14:51:46 ] |
Post subject: | Re: T3'12 weight |
Author: | Chicane [ Thu May 03, 2012 16:14:31 ] |
Post subject: | Re: T3'12 weight |
Author: | Green Wing [ Thu May 03, 2012 21:23:59 ] |
Post subject: | Re: T3'12 weight |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |