| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| Steering Angle https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=12528 |
Page 1 of 1 |
| Author: | Bonny [ Fri Apr 13, 2012 11:15:37 ] |
| Post subject: | Steering Angle |
Hi All Just in the process of rebuilding my t3 2012, and setting up the front toe and sterring locks at the moment, just wondering what steering angle people use in degrees at full lock, with 1 degree of toe out my car has 24deg steering angle, i think this is too high, just wondering what the recommended amount would be. Mark |
|
| Author: | Skiddins [ Fri Apr 13, 2012 15:17:49 ] |
| Post subject: | Re: Steering Angle |
I set my end points up so that the steering knuckles are just off the C-hubs. You can always limit the end travel on your transmitter to reduce the actual steering angle. I seem to recall Paul Lemieux talking about steering angles around 27deg for the inside wheel, and 21deg for the outside, but I could be wrong. |
|
| Author: | Hagberg [ Mon Apr 16, 2012 21:41:29 ] |
| Post subject: | Re: Steering Angle |
25 degrees |
|
| Author: | Ruben_qlc [ Tue Apr 17, 2012 22:55:07 ] |
| Post subject: | Re: Steering Angle |
25 degrees, for the inside or the outside wheel? |
|
| Author: | Hagberg [ Wed Apr 18, 2012 23:26:44 ] |
| Post subject: | Re: Steering Angle |
| Author: | Ruben_qlc [ Wed Apr 18, 2012 23:37:41 ] |
| Post subject: | Re: Steering Angle |
Yes ok, thank you very much. |
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|