XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
HUDY Alu servo horn https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=12466 |
Page 1 of 1 |
Author: | snowmiu19 [ Tue Mar 20, 2012 16:59:11 ] |
Post subject: | HUDY Alu servo horn |
Hello Xray Don't know where to pos about hudy products hope you can help. Im having trouble fitting the alu servo horn for futaba servo. It cannot go in smoothly. Is it a product defect? Thanks Regards Calvin |
Author: | Hagberg [ Tue Mar 20, 2012 22:36:43 ] |
Post subject: | Re: HUDY Alu servo horn |
Is it a new Futaba servo? I have seen people use it at my local track and it did fit so I don't think it's a general problem for this item. |
Author: | snowmiu19 [ Wed Mar 21, 2012 11:08:40 ] |
Post subject: | Re: HUDY Alu servo horn |
I try to fit it on a S9451 and also Savox low profile, both are difficult to go onto Thanks Regards Calvin |
Author: | Martin Hudy [ Fri Mar 23, 2012 15:51:07 ] |
Post subject: | Re: HUDY Alu servo horn |
Hi, futaba changed the size of the gear on their brushless servos. I have no idea what was the reason for that but becuase the Hudy horn was designed on the previous version, the servo horn goes harder on the brushless servos. But when you press it for the first time, afterthat it would work always smoothly. The same is Savox, their gear size is different than any other. We will make special servo horn for the new futaba and savox in the near future. |
Author: | snowmiu19 [ Mon Mar 26, 2012 10:59:04 ] |
Post subject: | Re: HUDY Alu servo horn |
Author: | Osorron [ Sun Aug 12, 2012 12:29:56 ] |
Post subject: | Re: HUDY Alu servo horn |
Hello, i lately read this post, i notice that the hudy horn does not fit well on savox servos, it happened what you have written but i try harder and it finally fit, hoping it does not get off the servo. |
Author: | Quincy [ Mon Aug 13, 2012 23:56:50 ] |
Post subject: | Re: HUDY Alu servo horn |
On t3 2012, what do you do in terms of spacing that alu horn? I've just got mine but not fitting quite right? Look forward to your response! |
Author: | Osorron [ Tue Aug 14, 2012 16:14:33 ] |
Post subject: | Re: HUDY Alu servo horn |
i put it on a savox servo, first i put some grease and then with a small hammer hit the horn obviously with the servo not mounted. i used it yesterday and have no problem. sorry about my english. regards |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |