XRAY - Model racing cars

Hi, here is our dusty low traction track:

http://www.youtube.com/watch?v=wPwUii2XyoM

What changes may I make to run with foams ?

Thank you

Nothing much, try the basic asphalt set up and work it from there. I also n on foams on low traction asphalt and my set up is quite good (it's basically the basic set up with minor changes). With foams it's very important to check ride height constantly, especially if you combine electric foams (which perform better) and nitro foams (which last A LOT longer but are slower than electric ones- great for practice) since they differ massively in their diameter. If necessary you can remove some screws from the top deck to get extra flex.

Thank you for your answer. So oil and springs are the same ? Camber positions? I´m a little lost

puno hvala

I use the same oil, 700 in the diff and 350 in shocks. Springs are also the same and work very good but I will try different combinations soon. There is already a thread on this subject (viewtopic.php?f=8&t=12385) with tips from our colleague Green Wing who also races on foams so you should check it out. What foams do you race on?

And you're welcome

Denis

I use Matrix and Enetti, 35 or 37 rear and 37 or 40 front ( depending off weather )

I will take a look to this thread.

Thank you again