| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| Diff oil problem https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=12457 |
Page 1 of 1 |
| Author: | Ruben_qlc [ Sat Mar 17, 2012 19:47:20 ] |
| Post subject: | Diff oil problem |
Hello everybody. Always the diff, oil leak out when runing. I revise all around the pulley, and sometimes in a part is a very little open, and when the car is runing, the oil leak out. Anyone know what am I doing bad? Thanks. |
|
| Author: | b.wihardja [ Sun Mar 18, 2012 02:35:44 ] |
| Post subject: | Re: Diff oil problem |
Check your o ring, I cut around 1mm if its swell. |
|
| Author: | Ruben_qlc [ Sun Mar 18, 2012 04:32:33 ] |
| Post subject: | Re: Diff oil problem |
Yes I cut a little the o-ring. Perhaps I cut too much. I have to check it. Thank you. |
|
| Author: | Andrew Webber [ Tue Mar 20, 2012 08:05:21 ] |
| Post subject: | Re: Diff oil problem |
I've run the Xray gear diff down to 600cst without any leaks. Make sure you dont over fill them, that you dont tighten the screws too much and when you're building the diff, place the large o-ring on the diff part that holds the gears, not the pulley part (and apply a tiny bit of oil to the o-ring prior to installing. Should be mint if you follow these tips. I dont recommend cutting the o-ring, replacing it is much easier and should guarantee a good seal. |
|
| Author: | Ruben_qlc [ Tue Mar 20, 2012 13:15:39 ] |
| Post subject: | Re: Diff oil problem |
My error may be over fill or overtighen the screws. I will try today, and put them if it is my error. Thank you. Regards. |
|
| Author: | Hagberg [ Tue Mar 20, 2012 22:37:42 ] |
| Post subject: | Re: Diff oil problem |
Replace the o-ring and paper seal. Don't overtighten the screws, and don't overfill the diff. I have had diffs which leaked in the past but I always replaced the o-ring and seal and after that they were fine. |
|
| Author: | Ruben_qlc [ Wed Mar 21, 2012 02:37:40 ] |
| Post subject: | Re: Diff oil problem |
Principa my error was cut too much the o-ring. And may be the over fill, and over tighten. Thank you very much guys. Regards. |
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|