XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Alloy shocks Bladder choice https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=12264 |
Page 1 of 1 |
Author: | Peter Phillips [ Wed Jan 25, 2012 18:29:28 ] |
Post subject: | Alloy shocks Bladder choice |
Hi, Hopefully Alex or Martin can answer this for me. Ive got a set of 308306-0 Alu Shock Absorbers for my T3'12. Just wonder if I should be building the shocks with the deep shock bladders supplied with them (as found on earlier xray models) or should I be using the narrow shock bladders as found with the T3'12 kit shocks? Thanks |
Author: | Martin Hudy [ Thu Jan 26, 2012 08:21:37 ] |
Post subject: | Re: Alloy shocks Bladder choice |
Hi Peter, does not matter. They both work good. Please be carefull and do not tight top cap too much when assembling the shock. This is the usual problem, driver tights top cap too much which leads to bend of the bladder. Afterthat driver cannot adjust rebound because of bend bladder. |
Author: | Peter Phillips [ Sun Jan 29, 2012 15:57:56 ] |
Post subject: | Re: Alloy shocks Bladder choice |
Hi Martin, Thanks for the reply. When building them i noticed if the shock is at full compression the deep bladders are slightly compressed by the piston assembly. If I install the shallow bladders the piston will i'm sure not reach the bladder. Which are you guys running? Or do you run both in different situations? Or does it make no difference? Peter |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |