XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Adjusting toe anterior https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=12062 |
Page 1 of 1 |
Author: | stevtec86 [ Tue Dec 20, 2011 14:51:25 ] |
Post subject: | Adjusting toe anterior |
Hi, I have a question about adjusting the front toe of my rods of Q3 2012: the instruction manual says to set the length of the rods to 65mm, and we know that in theory should be the convergence of 1 ° open right? My question is: to close the convergence of half a degree, the length of the rods as I bring? Example: 65mm = 1, open 64.50 mm = 0.5 ° open Thanks for any answers |
Author: | Martin Hudy [ Tue Dec 20, 2011 16:04:35 ] |
Post subject: | Re: Adjusting toe anterior |
yes, but better to check on the set up |
Author: | stevtec86 [ Tue Dec 20, 2011 20:47:21 ] |
Post subject: | Re: Adjusting toe anterior |
I know that the set-up system is much better, the problem is that my set-up system is broken, and in this moment I can not buy another .... then wondered if every half-millimeter corresponded to half can. However, you confirm that shortening / lengthening the rod half a millimeter at a time, closes / opens the convergence of half a degree (about)? Thank's for reply |
Author: | Stanley Bąk [ Sat Dec 24, 2011 18:54:37 ] |
Post subject: | Re: Adjusting toe anterior |
Author: | stevtec86 [ Sat Dec 24, 2011 20:25:21 ] |
Post subject: | Re: Adjusting toe anterior |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |