XRAY - Model racing cars

Hi,
Yesterday, after about 20 laps on a track with low traction asphalt, and fast, I noticed that the rubber latex, try for the first time on this model, the rubber on the inside, was worn down to the circle to be 'front and rear on the right side. The left side was too consumed inceve but not to the circle (though the tires were to be thrown away).
With the tires in the sponge and spread set-up, consumption was pittosto uniform .... Why?
Thanks for the replies
Stefano

do you have tweeked car?
what with balance right to left?
check your set up

i think that your track has got more lefty turns....

If you have right camber, than the problem is the tires. Some tires were out much more than others. For example, when I drive on my carpet track, with LRP tires I can drive 40 runs and no wear, with Ride tires, after 6 runs, i can see the wear on the inside side of the tire.

Ok, than's for reply Martin Hudy and Stanley Bąk.

Another question:
It may be that unusual for the consumption of rubber, could depend on the compound (incorrect temperatures)?

IO I rode soft compound rubber latex with temperatures around 10/15 ° C
Now I bought another train maca different and harder compound (compound 27 Takeoff, 10 ° C to 50 ° C as the track temperature).

PS from me at this time air temperatures do not rise above 10 ° C ever, so I guess that asphalt is quite cold

of course, more soft rubber more tire consumption. If you have super soft tires, you can destroy them even after one run