XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
T3 Roll bars https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=12026 |
Page 1 of 1 |
Author: | Luke123 [ Sat Dec 10, 2011 21:59:44 ] |
Post subject: | T3 Roll bars |
I can never get roll bars to be exactly the same for both side iv spent hours before trying to get the left the same as the right of left to right etc is there a trick to it ormsomething I'm missing? I make sure that my wishbone arms are perfectly free and match so ones not looser than the other etc. Any help would be brilliant |
Author: | Skiddins [ Sun Dec 11, 2011 17:26:00 ] |
Post subject: | Re: T3 Roll bars |
Take the roll bar out of the car and put it on a dead flat surface, if any part of it sticks up, it needs to be bent back into alignment. Skiddins |
Author: | Luke123 [ Sun Dec 11, 2011 18:31:30 ] |
Post subject: | Re: T3 Roll bars |
Ill check that later thank you |
Author: | b.wihardja [ Wed Feb 08, 2012 04:40:48 ] |
Post subject: | Re: T3 Roll bars |
After looking at "quick reference table", it's seem that the antiroll bar is very influential in setting, even more influential than the tire. Anybody confirm this? |
Author: | Hagberg [ Thu Feb 16, 2012 00:29:15 ] |
Post subject: | Re: T3 Roll bars |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |