give us some photos
If it touch a little u can use sand paper to grind topdeck in that place , but if a little. If more mabye you mounted
servo to high on alu stands to chassis
| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| T3 2012 servo link https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=12018 |
Page 1 of 1 |
| Author: | Maui_tim [ Thu Dec 08, 2011 07:05:10 ] |
| Post subject: | T3 2012 servo link |
I am attempting to use a KO PROPO RSX servo. Once the servo is assembled I go to hook up the servo link and that assembles fine, but I get interference between the top deck and the servo link when steering. I think have assembled per the instructions but I am missing something. I have the turnbuckle with the flats on the side closest to the servo. Any help would be great!! |
|
| Author: | Marek Gadomski [ Thu Dec 08, 2011 08:40:14 ] |
| Post subject: | Re: T3 2012 servo link |
give us some photos If it touch a little u can use sand paper to grind topdeck in that place , but if a little. If more mabye you mounted servo to high on alu stands to chassis
|
|
| Author: | Martin Hudy [ Thu Dec 08, 2011 09:32:24 ] |
| Post subject: | Re: T3 2012 servo link |
yes, please send the picture. I use same servo and have no problem |
|
| Author: | Skiddins [ Thu Dec 08, 2011 11:35:42 ] |
| Post subject: | Re: T3 2012 servo link |
| Author: | Maui_tim [ Thu Dec 08, 2011 15:12:48 ] | ||
| Post subject: | Re: T3 2012 servo link | ||
Here is a photo of the interference. THANKS!
|
|||
| Author: | Skiddins [ Thu Dec 08, 2011 16:23:59 ] |
| Post subject: | Re: T3 2012 servo link |
As I thought, you have the two plastic steering arms upside down. Look at the part of the manual I posted, they need to be the other way up. Should look lke this; Skiddins |
|
| Author: | Maui_tim [ Fri Dec 09, 2011 04:17:06 ] |
| Post subject: | Re: T3 2012 servo link |
Worked GREAT!! |
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|