XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Screw moves out by Driveshafts, what should i do? https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=11972 |
Page 1 of 1 |
Author: | Chrisi [ Thu Nov 24, 2011 10:58:56 ] |
Post subject: | Screw moves out by Driveshafts, what should i do? |
Hy all, by my Driveshafts every time the screw M3x2,5 is lossened and the pin 2x10 moves out. I take every time thread lock, but mostly some screw is lossened after few rounds. I had the Problem by the 2011 and now by the 2012 also. ![]() What should i do? Has anybody the same problem? I think i take the Dremel and made a little flat surface, but then the pin is weakened, and my 5.0 motor has much power. Maybe someone can help me by my problem. thx a lot Christian |
Author: | Skiddins [ Thu Nov 24, 2011 12:16:44 ] |
Post subject: | Re: Screw moves out by Driveshafts, what should i do? |
I use the pins which have a flat spot as standard, or I use a Dremel like yourself. It shouldn't weaken the pin too much as the small grub screw is only to stop the pin moving. Part Number 305392 SKiddins |
Author: | Chrisi [ Thu Nov 24, 2011 12:43:04 ] |
Post subject: | Re: Screw moves out by Driveshafts, what should i do? |
Thx for the part Number, i didnĀ“t know that this pin is also with flat spot available. Regards Christian |
Author: | mb3195 [ Thu Nov 24, 2011 13:15:48 ] |
Post subject: | Re: Screw moves out by Driveshafts, what should i do? |
the "top" brand of pins are much better, they have a much more obvious flat spot. Had no problems since changing to these. |
Author: | CharlesF [ Fri Nov 25, 2011 11:57:17 ] |
Post subject: | Re: Screw moves out by Driveshafts, what should i do? |
I grind a flat with a Dremel, and Loctite (or superglue) the grub screw in (with a VERY small amount of Loctite - otherwise you'll glue the joint up as well ![]() I've never had driveshaft pins coming loose after that. |
Author: | Hagberg [ Wed Nov 30, 2011 17:01:39 ] |
Post subject: | Re: Screw moves out by Driveshafts, what should i do? |
Try to use the flat spot optional pins! # 305392 |
Author: | BILKO1 [ Fri Dec 02, 2011 03:02:52 ] |
Post subject: | Re: Screw moves out by Driveshafts, what should i do? |
Put some heat shrink around the shaft, works for me as even if the screw loosens it won't fall out and trash the hub. |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |