XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Problem sliding rear lower arms https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=11967 |
Page 1 of 1 |
Author: | stevtec86 [ Tue Nov 22, 2011 20:09:02 ] |
Post subject: | Problem sliding rear lower arms |
Hi, i'm italian and my name is Stefano, and i have this problem: Today, by adjusting the rear camber by increasing the inclination inwards, I noticed that the smoothness from bottom to top and back, arm and lower back brake .... if you shrink the camnbre, smoothness rotorna excellent (bars with shock absorbers and detached). Who can tell me if it is normal or is there anything wrong? PS my model is new again, out of the box and is a 2012 T3 Thank you for any replies |
Author: | Marek Gadomski [ Tue Nov 22, 2011 21:10:45 ] |
Post subject: | Re: Problem sliding rear lower arms |
how much camber have you set |
Author: | taz00 [ Wed Nov 23, 2011 11:47:51 ] |
Post subject: | Re: Problem sliding rear lower arms |
With the gear diff and the 52mm driveshafts this is normal if you go over 2 degrees camber (in some cases maybe a bit more). A solution if you want to run more than 2 degrees camber is to grind down the plastic piece that goes on the driveshaft so that it does not bind in the gear diff's outdrives. |
Author: | stevtec86 [ Wed Nov 23, 2011 14:19:55 ] |
Post subject: | Re: Problem sliding rear lower arms |
Author: | stevtec86 [ Wed Nov 23, 2011 14:21:15 ] |
Post subject: | Re: Problem sliding rear lower arms |
Author: | taz00 [ Wed Nov 23, 2011 14:57:01 ] |
Post subject: | Re: Problem sliding rear lower arms |
I you want 3 degrees camber then grind down the plastic bit that goes on the driveshaft. |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |