XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
HELP With T3 New Diff https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=11837 |
Page 1 of 1 |
Author: | kenkeys [ Tue Oct 11, 2011 05:49:46 ] |
Post subject: | HELP With T3 New Diff |
I've just installed the New Diff on the rear of my T3 I'm using the 52mm drive shafts, the rear A arms do not drop down freely like they did before I checked roll pins, If I disconnect one side the other side drops freely. if they are connected at the same time they do not drop freely. anybody know why that is ? any sugguestions ? |
Author: | rduijkeren [ Tue Oct 11, 2011 08:04:42 ] |
Post subject: | Re: HELP With T3 New Diff |
Author: | Martin Hudy [ Tue Oct 11, 2011 09:10:29 ] |
Post subject: | Re: HELP With T3 New Diff |
Hi, Maybe rear track width is too narrow, Make sure to have 3 degree toe in and 1.5 degree camber. |
Author: | kenkeys [ Tue Oct 11, 2011 22:29:55 ] |
Post subject: | Re: HELP With T3 New Diff |
Hey thanks for the tip it did the job ! |
Author: | Martin Hudy [ Wed Oct 12, 2011 08:10:06 ] |
Post subject: | Re: HELP With T3 New Diff |
Great to hear ![]() In case you would like to use less toe in than 3 degree or use 1 degree rear hub, do not remove the 1.5mm shim but rather put shim into the front roll center holder on the rear arm. |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |