XRAY - Model racing cars

After running on the track today I'm finding the car is pushing too much and I want more on-power control. Here is my setup:

Any suggestions would be greatly appreciated.

Narrower shims at front wishbones
More front camber (possible more rear camber as well)
Less front droop
Possible harder front spring.

I would start with some of the above and see how they effect it.

Your camber's are what sticks out the most as you dont' have particularly heavy springs so any roll will remove a lot of the contact area of the tyres.

I would try the droop first. start simple obviously.

I will try less droop in the front to start with and test, then try the other suggestions.

I have the roll-center in the back to -0.75, I was wondering if it is worth changing that to 0.00.

At this point, I have plenty of rear traction but just want to add more on-power control as it forces me to let off on the throttle too much when I need to turn into a corner.