| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| t2 007 front axle https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=11684 |
Page 1 of 1 |
| Author: | Majr Chaos [ Wed Aug 31, 2011 01:25:17 ] |
| Post subject: | t2 007 front axle |
just wondering if the t3 solid front axle would fit the t2 007 |
|
| Author: | David_Ehrbar [ Wed Aug 31, 2011 09:28:56 ] |
| Post subject: | Re: t2 007 front axle |
It is the same except the 38T instead of 34. If you want to use it, you will have to change the diff and the belts. |
|
| Author: | Majr Chaos [ Wed Aug 31, 2011 13:50:49 ] |
| Post subject: | Re: t2 007 front axle |
would i need to replace the rear diff also ? would i use the t3 belts ? |
|
| Author: | Stanley Bąk [ Wed Aug 31, 2011 15:19:21 ] |
| Post subject: | Re: t2 007 front axle |
yes |
|
| Author: | Swanny [ Sun Sep 18, 2011 13:51:16 ] |
| Post subject: | Re: t2 007 front axle |
The information you've been given so far is incorrect. Whilst the T3 front sold axle may physically fit between the bulkheads, you will find that the pulley is offset differently to the T2 multi-diff, so the front belt will not line up. Save your money and don't buy it. |
|
| Author: | WheelNut [ Tue Sep 27, 2011 08:47:08 ] |
| Post subject: | Re: t2 007 front axle |
It doesn't line up, but it does still work. I've been using an '08 rear diff in my '07 for an entire season with no issues. I would imagine that the front would work out even better because the belt deflection will be at less of an angle (due to the longer distance). I'm planning on adding the 08+ front spool to my car later this season. Also note that Xray does make a 34t plastic spool (305184). Us 007 owners got kind of shafted with the 3.5mm driveshaft caps. We can't properly run them, so we have to either deal with deflected belts or forever break 3.0mm driveshaft caps. |
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|