XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
t2/t3 geometry differences? https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=11631 |
Page 1 of 1 |
Author: | JoelV [ Thu Aug 11, 2011 05:24:46 ] |
Post subject: | t2/t3 geometry differences? |
Hey guys, Have an 08 and wondering if the geometry has changed at all. I know a degree is built into the new car in the rear, but otherwise has width changed at all front/rear? Quick roll centers locations. Have they moved at all? I don't think so, but not sure. This picture says in and up, but I believe that's to do with the change to L1/L2's vs. the original. http://www.teamxray.com/teamxray/showim ... 71a2befbd6 Any help greatly appreciated. Thanks. |
Author: | Skiddins [ Thu Aug 11, 2011 14:50:43 ] |
Post subject: | Re: t2/t3 geometry differences? |
Can't speak for all of the car, but I know the rear roll centre holes in the shock tower are in different locations on the T3 from the holes on the 009 etc. Skiddins |
Author: | JoelV [ Wed Aug 24, 2011 04:10:28 ] |
Post subject: | Re: t2/t3 geometry differences? |
So I was able to measure a local racer's t3 but only the rear before he had to leave. The rear is 3mm higher. Does anyone know if the front moved higher as well? |
Author: | Phil C [ Wed Aug 24, 2011 11:08:56 ] |
Post subject: | Re: t2/t3 geometry differences? |
I believe the front height stayed the same, its just the rear that was raised to the same height as the front. |
Author: | Marek Gadomski [ Wed Aug 24, 2011 12:27:33 ] |
Post subject: | Re: t2/t3 geometry differences? |
front bulkheads are higher ![]() ![]() |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |