XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
One way newbie Q https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=1140 |
Page 1 of 1 |
Author: | Joep [ Tue Mar 01, 2005 10:43:20 ] |
Post subject: | One way newbie Q |
I was testing my drive train while the car was on a stand. I noticed that the outdrives from the one-way are able to travel from inner position to outer position over about 3-5 mm (or more). Is this normal or did I do something wrong ![]() |
Author: | projectnmt [ Tue Mar 01, 2005 10:55:01 ] |
Post subject: | |
Did you (you should) use the plastic spacer "washers" on the one way? These reduce the movement - but a small ammount is acceptable. |
Author: | Joep [ Wed Mar 02, 2005 10:00:21 ] |
Post subject: | |
Author: | projectnmt [ Wed Mar 02, 2005 10:13:43 ] |
Post subject: | |
Author: | brano [ Wed Mar 02, 2005 10:28:19 ] |
Post subject: | |
They are 6x9x2 plastic shims and you can find them in the |
Author: | Joep [ Wed Mar 02, 2005 10:29:44 ] |
Post subject: | |
Bought the kit 2nd hand. Have a bag with parts. Saw the washers in the parts database. Can you tell me how thick are? Then I can pick the right ones from the bag. ![]() |
Author: | Ole C [ Wed Mar 02, 2005 14:38:28 ] |
Post subject: | |
Author: | new92 [ Wed Mar 02, 2005 15:22:59 ] |
Post subject: | |
I bought a oneway that was new in the package from our race director. He still uses the original T1 and tons of original parts. The model he gave me was 305100 that has been replaced by 305101 and it didnt have any spacers or anything in the package. Just the pulley, oneway bearing piece, 3 screws, and the covers. Do I need to pick up some of the shims now? |
Author: | Joep [ Wed Mar 02, 2005 17:50:17 ] |
Post subject: | |
Author: | PlainOleDave [ Wed Mar 02, 2005 19:15:27 ] |
Post subject: | |
Author: | coledog855 [ Wed Mar 02, 2005 21:09:09 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |