XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Front gear diff https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=11383 |
Page 1 of 1 |
Author: | Craig McPhee [ Sun May 08, 2011 12:40:17 ] |
Post subject: | Front gear diff |
A couple quick questions about the front gear diff: 1. When packing it with cleaning gum, how much gum do you put in? Do you fill it up to the pin like with oil? 2. Can you use the 52mms unis when using the kit track width and a gear diff or do you need to use the 50mms Thanks! |
Author: | sidecarphil [ Sun May 08, 2011 20:10:59 ] |
Post subject: | Re: Front gear diff |
Quote: Originally Posted by sidecarphil1 Yeah i tried it with the 1.15mm spacers and you can use the 52mm shafts but you have to cut down the blades a lot , this makes them weeker and in Mod it is not strong enough , stock is ok though A liked the diff up front with 300,000 oil in it but it was slower so i took it out again Thanks for the response. I saw Hagberg uses cleaning gum in his so I was considering either using that or 500k. (taken from RCtech) ![]() ![]() ![]() ![]() |
Author: | S.A.W [ Sun May 08, 2011 22:37:06 ] |
Post subject: | Re: Front gear diff |
Hi, Tried a gear diff the other day in the front with 500,000 with 50mm driveshafts, not sure if I liked it though. It was smooth into the corners but seem to push on power out of the corners. |
Author: | Craig McPhee [ Mon May 09, 2011 02:54:29 ] |
Post subject: | Re: Front gear diff |
Author: | sidecarphil [ Mon May 09, 2011 07:26:36 ] |
Post subject: | Re: Front gear diff |
let me know how it goes , i would like to try it too |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |