Thankyou.
| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| Camber & upright/C-hub shims https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=11312 |
Page 1 of 1 |
| Author: | S.A.W [ Tue Apr 12, 2011 21:00:41 ] |
| Post subject: | Camber & upright/C-hub shims |
Hi, What effect does it give to the car if I increase or decrease camber on the front and/or rear ? and what does it do to the handling if I add or remove shims on the uprights or c-cubs ? as I see alot of setup sheets where people adjust the shim thickness. Thanks. |
|
| Author: | Steve Weiss [ Wed Apr 13, 2011 02:08:18 ] |
| Post subject: | Re: Camber & upright/C-hub shims |
Generally, increasing camber on one end of the car will result in more traction at that end to a point. Genearlly, I do not exceed 2.5 degrees of camber at either the front or the rear under most circumstances. I generally start out with 1.5 degrees in the front and 2 in the rear and adjust for balance as needed. shims underneath the camberlinks on the front or rear hubs is a little different matter. Generally, a flatter camberlink in the front will result in faster direction transitions and sometimes steering into the corner. Adding shims to the front will generally reduce the transition speed but increases steering from the middle of the corner and out in most circumstances. Generally, running a flatter rear camberlink will result in more weight being transferred forward when entering a corner but generally less rear traction being available in the middle or exit of a corner... the car may have a tendancy to have the rear end step out more abrubtly as well. Adding sihms to the rear will generally make any loss of traction in the rear more gradual and generally your car will have more side bite as well. Every tire and track react differently to camber and cambergain, so I would recommend making small changes in your camber 0.5 degrees or camberlinks of 0.5 mm shims at a time to see what the effect is for you. |
|
| Author: | Craig McPhee [ Wed Apr 13, 2011 06:33:21 ] |
| Post subject: | Re: Camber & upright/C-hub shims |
^^^ Great post! |
|
| Author: | S.A.W [ Wed Apr 13, 2011 09:17:10 ] |
| Post subject: | Re: Camber & upright/C-hub shims |
Thankyou.
|
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|