XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
speedpassion pro 2 in t3 problems https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=11305 |
Page 1 of 1 |
Author: | moggy12 [ Sun Apr 10, 2011 17:15:42 ] |
Post subject: | speedpassion pro 2 in t3 problems |
hi i have the speedpassion pro 2 esc in my xray t3 touring car last few weeks been having problems with it loosing power after 3mins like it is in sensorless mode i have changed sensor cable and sensor board in my 13.5 speedpassion v3 motor first few mins the t3 flies great top end and great accelaration motor is coming of at 72 c i have fdr of 6 esc is not over heating as no light flashing on it after 5 mins racing here are my settings forward only drag brake force 25% drrs punch level 8 brake force 75% initial brake 0% neutral range 6% amts timing level 8 sc boost level 7 sc rpm delay 4000 full throttle delay 0.1 sc punch level 4 any ideas or settings to change to would be most appreciated ps i have new 5800 60c lipo batterys |
Author: | David_Ehrbar [ Mon Apr 11, 2011 12:51:59 ] |
Post subject: | Re: speedpassion pro 2 in t3 problems |
Deactivate Thermal protection. Then your problem should be solved. If not, set Lipo Cutoff to 3.0 or 2.8 |
Author: | Zink [ Mon Apr 11, 2011 18:57:02 ] |
Post subject: | Re: speedpassion pro 2 in t3 problems |
Have you ever tried a higher fdr? About 6.5-7.5? |
Author: | moggy12 [ Mon Apr 11, 2011 20:28:25 ] |
Post subject: | Re: speedpassion pro 2 in t3 problems |
hi thanks for info i had lipo cut of at 3v have changed to 2.8 what would i gain from rising fdr to 6.5-7.5 ? |
Author: | moggy12 [ Fri Apr 15, 2011 17:09:57 ] |
Post subject: | Re: speedpassion pro 2 in t3 problems |
was still going slow on 2.8 per cell so knocked protection to off which did the trick thanks |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |