XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Maximum traction and additive aplication https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=11111 |
Page 1 of 1 |
Author: | Ruben_qlc [ Fri Feb 04, 2011 17:47:42 ] |
Post subject: | Maximum traction and additive aplication |
Hello everybody. I have a race in next weeks. The race is on carpet and mixed on rubber. I have just buy the xray t3'11. But, I would like to know what is the ideal combination of: spur, pulley, pinion, for maximum power and traction, because race is on stock motor 10.5. I have another question about additive. What is the normal aplication today? I donĀ“t run since mixed of 2010. I have listen that you can put the additive on rear tyres, and wait 5-10 min, and then put the additive in front tyres. Is this correct? Thank you very much. Best regards, |
Author: | steven olsen [ Sat Feb 05, 2011 08:53:01 ] |
Post subject: | Re: Maximum traction and additive aplication |
Author: | Ruben_qlc [ Sat Feb 05, 2011 12:43:56 ] |
Post subject: | Re: Maximum traction and additive aplication |
Thank you very much Steven. And about the spur, is better 48 module or 64 module ??? I recent just seen a setup of Hudy on carpet and he uses 114 of 64 module I think. Do you recommended me buy the 'SXX Stock-Spec Brushless ESC - RED DOT MK3' for stock races on carpet?? Regards, |
Author: | Ruben_qlc [ Sat Feb 05, 2011 13:17:41 ] |
Post subject: | Re: Maximum traction and additive aplication |
Sorry: Do you recommended me buy the 'SXX Stock-Spec2 Brushless ESC - RED DOT MK3' for stock races on carpet?? And Which motor (4.5, 5.0 or 5.5) do you recommended me for asphalt race in a medium track? Thank you very much again for all. Best regards, |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |