XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
t3 11 servo choice https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=11087 |
Page 1 of 1 |
Author: | wild-bill [ Sat Jan 22, 2011 07:01:10 ] |
Post subject: | t3 11 servo choice |
Which servos will mount in the narrow mounting positions and allow the most room for electronics in the t3 11? Request pics if available.... Anyone using futaba Rx/tekin RS combo? |
Author: | Browny_37 [ Sun Jan 23, 2011 02:32:06 ] |
Post subject: | Re: t3 11 servo choice |
Im using a Savox Low Pro with a Tekin RS Pro, which uses the furthest most rear mounting post for the servo. Things are a little tight, ive had to stand the Reciever on its edge to get things to fit. |
Author: | wild-bill [ Sun Jan 23, 2011 03:27:13 ] |
Post subject: | Re: t3 11 servo choice |
Author: | Browny_37 [ Sun Jan 23, 2011 14:33:00 ] |
Post subject: | Re: t3 11 servo choice |
I'm afraid not Wild-Bill, i know the Spektrum HS6040 servo should be avoided as its absolutely huge for a Touring Car. It is a 600 scale helicopter servo anyhow. |
Author: | wild-bill [ Mon Jan 24, 2011 05:13:39 ] |
Post subject: | Re: t3 11 servo choice |
Anyone else??????? ![]() ![]() |
Author: | snowmiu19 [ Fri Jan 28, 2011 06:05:28 ] |
Post subject: | Re: t3 11 servo choice |
Im using KO-PDS-2413ICS and tiny KR-407S Micro Receiver and Tekin RS lots of room for everything. Regards Calvin |
Author: | Denney [ Fri Jan 28, 2011 23:00:50 ] |
Post subject: | Re: t3 11 servo choice |
I'm currently using an Airtronics 94358 that fits the narrow chassis holes. With a Tekin RS & Futaba FASST receiver I still needed to mount the receiver on it's side to get enough motor movement (98 spur 44 pinion put the motor right up to the Tekin). All would fit flat if I were willing to cut off a servo ear...but I think that's true with most servos. Denney |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |