XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
HELP!!!! PLEASE HELP!!!! DRIFTING QUESTION https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=11003 |
Page 1 of 1 |
Author: | Tomace01 [ Wed Dec 15, 2010 21:13:36 ] |
Post subject: | HELP!!!! PLEASE HELP!!!! DRIFTING QUESTION |
I just bought a XRAY T3 2011 and a bunch of hop up parts. Bought this car to drift with. Haven't put this kit together yet. Wanting to know how to set this car up for drifting? Bought a multi-diff one-way for the front. What else do I need in order to set this car up for the ultimate drifting experience. PLEASE, PLEASE help me out. Any and all advice will be truly appreciated. New to the drifting scene. Thank you so very much... |
Author: | sidecarphil [ Thu Dec 16, 2010 22:10:29 ] |
Post subject: | Re: HELP!!!! PLEASE HELP!!!! DRIFTING QUESTION |
put the spool in the rear and the ball diff in the front after that i am no use sorry , Try www.RCdrift.com these guys are quite helpfull |
Author: | rrcyborg [ Thu May 26, 2011 14:45:40 ] |
Post subject: | Re: HELP!!!! PLEASE HELP!!!! DRIFTING QUESTION |
Chassis : Xray T3 2011 EU Moteur : HPI Flux 5700Kv (Castle Création) Vario : HPI Flux (Castle Création) Radio : Spektrum DX3S et récepteur SR3300T Servo : Futaba S3010 Battery : Lipo Orion 2400 and Lipo Kypom 5800 charger : Orion Clubman Lipo options : # Chassis CS 1,49% # 38/16 for front and 20/32 for rear # Central pinion 16T (ref 305570) # Rear Diff 32T (ref 305051) # Front belt 512mm => 507mm (ref 305431) # Rear belt 189mm => 183mm (ref 305444) # Multi diff "one way" (ref 305105) # Universal Swing Shaft Spec R (More angle) # Steering block resized to increase the steering angle # Pitman Direction made with a threaded rod of 3mm diameter # No Ackerman effect. # Editing anchor points on the shock front suspension arm for more angle. # Spring Hard (ref 308387) I hope this can help you |
Author: | Stanley Bąk [ Thu May 26, 2011 15:34:43 ] |
Post subject: | Re: HELP!!!! PLEASE HELP!!!! DRIFTING QUESTION |
and remember set camber for 0*!!! |
Author: | sidecarphil [ Thu May 26, 2011 19:01:51 ] |
Post subject: | Re: HELP!!!! PLEASE HELP!!!! DRIFTING QUESTION |
your rear belt is way too loose ![]() ![]() ![]() |
Author: | rrcyborg [ Fri May 27, 2011 13:13:13 ] |
Post subject: | Re: HELP!!!! PLEASE HELP!!!! DRIFTING QUESTION |
Yes of course ![]() I need to change the pinion of 20t with that of 25 for the rear and as the belt is tight 38/16 front and 25/32 rear => CS 1.85 Camber => Front 6° rear 3° Thank you for reading ![]() |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |