XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Ali quick roll centres https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=10894 |
Page 1 of 1 |
Author: | Quietman [ Tue Oct 26, 2010 00:14:53 ] |
Post subject: | Ali quick roll centres |
HI It says only use them with the symbol upwards,so if you use them with the symbol up then alter it so it is turned the other hole do you have to swap them from side to side to keep the symbol up,if so why do you have to keep them symbol up? Thanks |
Author: | Martin Hudy [ Wed Oct 27, 2010 16:21:12 ] |
Post subject: | Re: Ali quick roll centres |
Hi, for the L and H roll centers, only position 3 (according to manual) should be used. The other holes are for roll-center #303032. Please see manual page 18. It is explained there |
Author: | Rouge [ Fri Oct 29, 2010 21:39:11 ] |
Post subject: | Re: Ali quick roll centres |
Hi all guys, i'm from Italy. I was looking for info about quick roll center specially about L and H. Ok Martin this is clear but in your Kastellaun setup is there a mistake? At rear end it is marked H quick roll centers and they are marked position 4. Only 3 is allowed, right? And what about camber link location? 1 or 2? Tnx! |
Author: | Quietman [ Sat Oct 30, 2010 15:42:28 ] |
Post subject: | Re: Ali quick roll centres |
Hi What is the difference between the h and the L holders if used on the same position on tower and hub and just the holders changed what would it change between them? Thanks |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |