XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Corner entry grip roll https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=10745 |
Page 1 of 1 |
Author: | michaelbranthwaite [ Wed Aug 11, 2010 11:33:46 ] |
Post subject: | Corner entry grip roll |
Hi I had my car pretty much where I wanted it last night at my local club. The only issue was grip rolling on corner entry , high speed corners slowing and entering a corner. Has any one any ideas on how to cure this? I thought of anti-dive/ raising roll centre but do not want to lose the steering I have for the rest of the corner. I have recently installed a gear diff and have 60wt oil in which is very thin, if this was thicker , say 2000, do you think the diff would push the car more, rather than letting it turn in so hard? cheers in advance, M |
Author: | Skiddins [ Wed Aug 11, 2010 14:42:36 ] |
Post subject: | Re: Corner entry grip roll |
I would raise the front roll centres at the pivot pin. Also consider trying softer springs front and rear. Skiddins |
Author: | racerlog [ Wed Aug 11, 2010 15:14:09 ] |
Post subject: | Re: Corner entry grip roll |
Post your setup. This is on carpet right? ? Going wide front and rear always helps. I run my carpet cars at 189mm wide front and 187/188mm wide in the rear. |
Author: | michaelbranthwaite [ Wed Aug 11, 2010 15:59:30 ] |
Post subject: | Re: Corner entry grip roll |
Author: | michaelbranthwaite [ Wed Aug 11, 2010 16:08:48 ] |
Post subject: | Re: Corner entry grip roll |
This is the set-up I used, do you think the rear diff being 'loose' would affect this? xform/index.php?act=view&ID=2196&setup=t2_008 |
Author: | WEBBY1977 [ Wed Aug 11, 2010 20:43:03 ] |
Post subject: | Re: Corner entry grip roll |
use thicker gear diff oil/grease, this will help alot |
Author: | Skiddins [ Thu Aug 12, 2010 01:33:56 ] |
Post subject: | Re: Corner entry grip roll |
Go wider at the wishbones. I use 1.5mm shims and the high roll centres. |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |