XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
T3 epa setting is it an issue?? https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=10617 |
Page 1 of 1 |
Author: | blade072 [ Sun Jun 27, 2010 07:16:01 ] |
Post subject: | T3 epa setting is it an issue?? |
hello have just built and tested the t3 by doing a circle diameter steering test.... i have set maximum steering using the following epa settings to get the same steering both ways right 85 left 70 as i would never probably use so much steering, would you say this is an issue at all??? thanks David |
Author: | sidecarphil [ Sun Jun 27, 2010 12:36:23 ] |
Post subject: | Re: T3 epa setting is it an issue?? |
i think my EPA's are about 75 left and 83 right and the car is perfect i think it is something to do with the servo horn position on the car but unsure |
Author: | blade072 [ Mon Jun 28, 2010 10:08:02 ] |
Post subject: | Re: T3 epa setting is it an issue?? |
Author: | David_Ehrbar [ Tue Jun 29, 2010 12:10:25 ] |
Post subject: | Re: T3 epa setting is it an issue?? |
It is important that you have max throw to both sides. Most times it is not the same % on your transmitter as the linkage between servo and servo saver is not symmetric. you have to adjust both sides seperate so that the steering arm just touches the c hub at max throw. This is the same for all current TCs. |
Author: | blade072 [ Tue Jun 29, 2010 12:40:48 ] |
Post subject: | Re: T3 epa setting is it an issue?? |
thanks for the very simple explanation david....and have set both epa's so they just hit the hubs evenly..so it looks like all i have to worry about now is dual rate...correct??? ![]() |
Author: | 20 SMOKE [ Wed Jun 30, 2010 02:29:59 ] |
Post subject: | Re: T3 epa setting is it an issue?? |
i have found that with a sub trim setting on a radio you get the tie rods the same or near perfect |
Author: | David_Ehrbar [ Wed Jun 30, 2010 09:31:11 ] |
Post subject: | Re: T3 epa setting is it an issue?? |
Author: | blade072 [ Wed Jun 30, 2010 09:37:02 ] |
Post subject: | Re: T3 epa setting is it an issue?? |
Author: | blade072 [ Wed Jun 30, 2010 09:38:23 ] |
Post subject: | Re: T3 epa setting is it an issue?? |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |