XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Spare parts to have on hand (with part numbers for T2'007) https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=10464 |
Page 1 of 1 |
Author: | mamac [ Mon May 10, 2010 22:35:46 ] |
Post subject: | Spare parts to have on hand (with part numbers for T2'007) |
Author: | YELLOWSHARK [ Wed May 12, 2010 01:33:12 ] |
Post subject: | Re: Spare parts to have on hand |
Belts The small (2mm?) grub screws so you can rebuild a driveshaft - I normally have two ready built in the pit box Grease for above and loctite Steering block Rear upright Shock diaphragms C-hub - they are sided so two ( to be honest I do not think I have ever had one break) Spare pack of the plastic roll bar holders. The number of times I have set droop and forgotten to tighten the roll bar holder screws ![]() Maybe a spool outdrive - in 3 years I have broken one I travel with much more than the above but I have never had to fix anything else. For a big meeting I think bearings would be useful - wheel bearings if nothing else. |
Author: | mamac [ Fri May 14, 2010 07:38:35 ] |
Post subject: | Re: Spare parts to have on hand |
Author: | YELLOWSHARK [ Fri May 14, 2010 22:31:39 ] |
Post subject: | Re: Spare parts to have on hand |
Right on the membrane but the grub screws are 901302 3mm*2.5 - if you are using the standard the drive shafts; I should remember but cannot recall if the ECS driveshafts use the same size or smaller. It is worth having a pack of driveshaft pins too. Either 9080210 for the 9.8 with square ends or 305392 for the 10mm ones with flat spots. I prefer the latter but they are 5 times more expensive! And you can flat spot your own. |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |