XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Need cure for high speed push https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=10407 |
Page 1 of 1 |
Author: | Me [ Fri Apr 23, 2010 12:00:17 ] |
Post subject: | Need cure for high speed push |
![]() Someone else said that if the rear diff was too tight that it would cause lack of steering. |
Author: | Skiddins [ Fri Apr 23, 2010 14:43:22 ] |
Post subject: | Re: Need cure for high speed push |
This thread had a similar question and the replies helped cure what your describing as well. Skiddins |
Author: | Martin Hudy [ Wed Apr 28, 2010 11:08:01 ] |
Post subject: | Re: Need cure for high speed push |
Hello, -0.75 roll center will give you more steering into the corner but does not solve on power push. If you want to increase cornering speed, lay down rear shocks into second position from bottom, use 1.3 rear anti roll bar, put 2.8 springs into rear shock, and rise the rear roll center by +0.75. All these set up changes will give you better cornering speed and solve problem with on power push. |
Author: | ATLASCOPCO [ Sun May 02, 2010 21:20:15 ] |
Post subject: | Re: Need cure for high speed push |
Will this make the rear of the car loose |
Author: | Martin Hudy [ Mon May 03, 2010 10:09:08 ] |
Post subject: | Re: Need cure for high speed push |
Yes, little, always when you want to increase on power steering, you decrease rear traction. I would try all these combinations to find balance between steering and traction |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |