XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
T3 With 6.5T Motor https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=10398 |
Page 1 of 1 |
Author: | KingPin [ Tue Apr 20, 2010 01:24:31 ] |
Post subject: | T3 With 6.5T Motor |
Hi, Recently I purcharsed a new T3 and I have this brushless combo: I want to know if somebody can tell me a pinion to start with. I´m new in electric cars, I came form nitros. I will use 7.4v lipos and the straight of my track is about 40m. I just want to know a pinon to begin testing. Thanks.- |
Author: | KingPin [ Thu Apr 22, 2010 13:33:39 ] |
Post subject: | Re: T3 With 6.5T Motor |
60 visits and no answers. ![]() Please, help me !!! Can anyone tell me a pinion to start working with ??? 6.5T motor. Just a pinion to start testing different ones. Thanks |
Author: | David_Ehrbar [ Thu Apr 22, 2010 16:16:45 ] |
Post subject: | Re: T3 With 6.5T Motor |
You can start with 23-30 if you use 48db, depending on your track. |
Author: | KingPin [ Thu Apr 22, 2010 23:55:07 ] |
Post subject: | Re: T3 With 6.5T Motor |
Thanks David. Will try with a 23. Thanks |
Author: | JPSRACING [ Sat Apr 24, 2010 13:30:43 ] |
Post subject: | Re: T3 With 6.5T Motor |
I have the same car with 5 turn LRP, same battery etc. the 23 T pinion is good but I am advised that it is a little big and I need to go smaller. Even tho I am happy with the 23 T I have tried a 29T which causes the motor to over rev and thus drain the battery way to quick!!! My advice is try the 23T and then buy a few lower like 16-20 and have a try with them. I have just put in a 19 T. If you want rollout charts from different pinions there is a chart that came with yr T3 or go to gearchart.com, im sure that will help ya. |
Author: | Svanur [ Mon Apr 26, 2010 14:31:52 ] |
Post subject: | Re: T3 With 6.5T Motor |
I have been using 19 to 24 with 6.5 turn motor. Usually I use 20-22 mm but as always it depends on the track ![]() |
Author: | David_Ehrbar [ Mon Apr 26, 2010 15:37:21 ] |
Post subject: | Re: T3 With 6.5T Motor |
Author: | KingPin [ Wed Apr 28, 2010 04:43:37 ] |
Post subject: | Re: T3 With 6.5T Motor |
Thanks for your comments. Helped me a lot. I will buy a 23T and try it. Then I will buy a smaller or a bigger pinion, to continue testing. THANKS !!!! |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |