XRAY - Model racing cars

I found error a error in instruction manuals of 008, 009 and T3 cars.
It is kind of minor, if you are experienced driver and have knowledge how to properly set your shocks.
But in the other hand, if you are a newbie and building your car by the book, you'll end up in troubles.

Anyway the error is about Shock Rebound.
There isn't mentioned that you have to turn the shock upside down.
So, it is guaranteed that you'll make your shock building a nightmare if you do it by the book (and not put shocks upside down).

Funny thing is that the manual of the T2 and 007 is correct, here is a quote:
"
Shock bleeding:
Turn the shock upside down and pull the shock rod out to full extension. Release the shock end-cap by turning it CCW and pulling it slightly
away from the shock body. Let the shock “vent” for at least 10 minutes; excess oil should seep out the end of the shock body.
"

I hope that Xray addresses this problem.
Thank you!

That's actually pretty funny.. I never noticed that, but always did it anyhow lol. Good catch

Sorry if I am being a bit stupid here but by upside down does it mean that I open the bottom of the shock , turn it upside down, and then pull the shock piston upwards if you know what I mean.