XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
T2'007 Breaking drive shaft blades https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=10143 |
Page 1 of 1 |
Author: | WheelNut [ Mon Feb 01, 2010 08:07:20 ] |
Post subject: | T2'007 Breaking drive shaft blades |
Author: | 20 SMOKE [ Mon Feb 01, 2010 14:58:18 ] |
Post subject: | |
Author: | WheelNut [ Mon Feb 01, 2010 22:00:17 ] |
Post subject: | |
Author: | MattWinyard [ Thu Feb 04, 2010 00:59:04 ] |
Post subject: | |
Author: | WheelNut [ Thu Feb 04, 2010 23:01:32 ] |
Post subject: | |
I've got 007 blades. 3mm pieces of junk. I was just wondering what guys were doing to stop the from breaking. This must have been a big issue back in 2007. I'm probably just going to put a 008 front spool into the car even though it doesn't fit quite right. The 008 rear diff seems to holding up good enough after all. |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |