I've recently purchased a T3 and the Hudy Ultimate Setup station and have been working on some setups for the local track. I find the station easy to use except for the tweak.
I attach everything to the car as the book says and place on the tweak station, press down on the front and rear shock towers to settle the suspension and take a look. What happens then is I notice if I tap the tweak station at the edge where the measurement ticks are, it will not settle back in to the same location each time. This makes me think that trying to adjust for this is useless since I can't be sure I'm getting an accurate reading.
Is there a trick to getting the car to settle properly on the tweak station so that I can make adjustments and recheck with accuracy?
Thanks!
|