XRAY - Model racing cars

Does anyone have a good setup for mod on low grip asphalt and rubber tires?
Here's was my current setup that I can't seem to get work. http://www.teamxray.com/xforum/xform/in ... tup=t1fk05
Thanks for your input.

Hi

if you could be a little bit more specific with the problem you are having then maybe we will be able to help you a more but by looking at your setup i think that your car may be oversteering way to much having the front toe out at 2* is way to much you should try it at maybe 0.5 or 0* toe in i also think you have the rear springs to hard and that means that the front is digging in to much and the rear not enough and is oversteering which will be causing the rear end to brake away also using 2mm indoard toe out on the front will make it feel very twitchy and the steering quite responsive if i was you these are the things i would change first if that is the problem you are having mind you

Ben

The problem was that the car would under steer on power but would over steer off power at high speeds, most of the changes I tried on the day didn't do a thing to the over steer but would sometimes stop the under steer. No matter what changes I made the car would still over steer off power at high speeds. I did have a problem with over heating tires but even at the start of the race I would have these problems.

I surgest you try the things i surgested above i would go to a softer rear spring say blue and run the front with no spacer between the arm and run the front toe at 0 this should be pointing you in the right direction

Hope this helps
Ben