Joined: Wed Feb 15, 2006 13:52:32 Posts: 70 Location: Adelaide, Australia
|
Is it just me or does anyone else find that it's fairly easy to strip the threads in the the gear diff?
First time it happened to me was when I first built it.
Is there a better screw out there that can be used other than the M2.5 ones included, such as a self tapper?
Seems you have to be careful not to get any oil or spray in the holes, otherwise it strips.
If I'm going to keep stripping screws out, I think I'll go back to the ball diff as it gets expensive to keep replacing the casing.
|
|