XRAY - Model racing cars

Hello everybody.

Actually from 1997 I use radio Futaba 3VC, this is very old. I can't use exponencial steering, and others configurations. I just go to buy the sanwa exzes x, is the radio that jilles groskamp and andy moore, etc. uses.

Do you think I will improvement?

Thank you. Regards.

Probably won't make any difference.

You do have Expo on the steering on the 3VC (it's what I use)



The wheel version of your radio, settings are the same.

Skiddins

P.S. You asked about Expo a few months back

Thank you for your answer. But my radio is 3VC, not the 3VCS. I think that it can't buy today.

I can't configurate the exponencial because is too old, and the younger servos are from other technologies:
"When I turn the exp steering to -50% for example, the wheels turn to the right. When you change the exp steering the wheels musn't turn. Other example is on brake. It only works when I apply the full brake stick."
When I turn left to right. Wheels have a lot of vibration.

Perhaps I would do a video for other people can see it.

Sorry for my english.

Thank you Skiddins.

Hello Skiddins.

My receiver is Futaba R603FS Specktrum.
And the servo steering is Airtronics digital servo 94746.

Regards.

Check if the receiver needs the transmitter to be set to PPM or PCM mode.

Skiddins

To get EXP, press 'Direct' then press the top middle button 'ST.EXP', that's it, steering expo.

I don't remember if the radio uses PCM o PPM, I think is PPM. I will see today.

About the steering exp, yes is that configuration that I try to change, but impossible jaja.

Thank you. I tell you something this night.

Regards.

Sorry for late Skiddins.

I use PPM module.

Regards.