| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| Wire Anti Roll Bar Play? https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=47&t=18718 |
Page 1 of 1 |
| Author: | rcbo [ Fri Jun 20, 2014 05:11:38 ] |
| Post subject: | Wire Anti Roll Bar Play? |
I haven't done a direct comparison but how can an anti roll bar with a lot of mechanical play be better than the old blade type? If I disconnect the shocks and put a 8mm drill bit under the chassis, I can lift the left wheel at least 6-7mm before the right side wheel start to move. If I do so with the blade type the right wheel start to move when the left wheel is lifted only 2mm. |
|
| Author: | JamesHealey [ Wed Jun 25, 2014 07:57:54 ] |
| Post subject: | Re: Wire Anti Roll Bar Play? |
Should be lifting about 2-3mm, shouldnt have that much play. The Blade is more direct you're right but not by that much! |
|
| Author: | MPesenti [ Wed Jun 25, 2014 16:03:07 ] |
| Post subject: | Re: Wire Anti Roll Bar Play? |
You just have to setup the play in order that the antirollbars have the same play on the both sides (or better no play). |
|
| Author: | rcbo [ Wed Jun 25, 2014 19:19:40 ] |
| Post subject: | Re: Wire Anti Roll Bar Play? |
| Author: | rcbo [ Wed Jun 25, 2014 19:45:50 ] |
| Post subject: | Re: Wire Anti Roll Bar Play? |
| Author: | david133 [ Fri Jun 27, 2014 19:09:20 ] |
| Post subject: | Re: Wire Anti Roll Bar Play? |
Hello, My friends and me had exactly the same problem here in France. I will be enough honest with you to let you know that we put the old anti roll bar that are pretty good. Like you, i had a headache set up the new anti roll bar! regards from france, David |
|
| Author: | rcbo [ Sat Jun 28, 2014 15:12:26 ] |
| Post subject: | Re: Wire Anti Roll Bar Play? |
| Author: | Green Wing [ Fri Jul 11, 2014 16:16:21 ] |
| Post subject: | Re: Wire Anti Roll Bar Play? |
Make sure the anti roll bar holders that go into the bearings are mounted exactely the same. This means, the setscrews both have to be in exactely the same position and angle to the anti roll bar. Otherwise it sits not correct in the bulkheads already. You can compare a different angle pretty much to when you use different positions left and right of the belt tensioner excenters. The ultra stable clutch spring needs MUCH less preload than other ones. When setting it up like the 'standard' 1mm thread left on the flywheel nut, the clutch will never engage, even not on the box under full throttle. I also run it at .3mm and set it up in quater turns which makes a huge difference on the US spring already. |
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|