XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Maintenance https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=47&t=13613 |
Page 1 of 1 |
Author: | mcpc [ Tue Jul 30, 2013 07:31:35 ] |
Post subject: | Maintenance |
Hi All, I'm a newbie to 1/8 onroad nitro RC. I have an Xray Rx8 2013. I just wanted to ask about maintenance. So far my list includes: 1. Engine - use after run 2. 1st gear and front axle one-way bearings - Clean and one-way lube 3. Thrust bearing - clean and grease with graphite grease 4. Clutch - check clutch gap and end play 5. Air filter - clean and oil using filter oil 6. ball bearings - oil using bearing oil 7. Wipe down chassis with a towel Is there anything else I need to do to maintain the car and minimize failures? Thanks in advanced. |
Author: | Roelof [ Tue Jul 30, 2013 19:31:47 ] |
Post subject: | Re: Maintenance |
- clean belts and pulleys - oil belts (use some WD40 or silicone spray) - check and re-adjust play om pivot balls - check the setup |
Author: | mcpc [ Wed Jul 31, 2013 03:44:09 ] |
Post subject: | Re: Maintenance |
Thanks Roelof! |
Author: | jermen [ Mon Aug 05, 2013 19:30:17 ] |
Post subject: | Re: Maintenance |
- lube one way bearings with oneway lube (gearbox and front one ways) - lube dogbones with premium lube ore some light grease - check shocks for air (less often) - clean inside 2nd gear (moving parts cause allot of alu wear on shoe and bell) - check if suspension still moves freely without shocks attached. |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |