XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Not getting enough Camber settings https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=21&t=9537 |
Page 1 of 1 |
Author: | trini [ Sun Aug 02, 2009 18:30:20 ] |
Post subject: | Not getting enough Camber settings |
Author: | _cyclops_ [ Mon Aug 03, 2009 08:42:35 ] |
Post subject: | Re: Not getting enough Camber settings |
Author: | trini [ Mon Aug 03, 2009 14:54:31 ] |
Post subject: | |
Author: | ds motorsport [ Mon Aug 03, 2009 18:19:45 ] |
Post subject: | |
Author: | trini [ Mon Aug 03, 2009 19:08:14 ] |
Post subject: | |
Author: | grub [ Tue Aug 04, 2009 09:51:11 ] |
Post subject: | |
looking at the photo's looks like you have 2 diffrent ball joint ends on the left hand`side.the left ball end looks like the sway bar joint and the right one looks like the shorter camber one. the correct one ... there are 4 diffrent size ball joints one for the sterring 21.05 ml the other for the sway bar 18.80ml the sterring servo 16.20ml and the rear camber adjustment 19.25ml..you can measure the ball joint these are overall lengths ,you might wonna check them i have made this mistack myself |
Author: | trini [ Tue Aug 04, 2009 14:44:08 ] |
Post subject: | |
Thanks Grub, I will give it a measure |
Author: | trini [ Fri Aug 14, 2009 04:12:34 ] |
Post subject: | |
Author: | _cyclops_ [ Fri Aug 14, 2009 11:41:33 ] |
Post subject: | |
Author: | trini [ Fri Aug 14, 2009 13:59:35 ] |
Post subject: | |
Dremel the turnbuckles, is that what everyone is doing to get the stock settings. I does not seem right, to cut new turnbuckes, the manual does not indicate anything like that. Here are some pictures I took last night(phone) |
Author: | trini [ Fri Aug 14, 2009 19:34:19 ] |
Post subject: | |
Has anyone used the No. 4 position on the camber link mounting postion and experience the same issue ? |
Author: | ZacLuc888 [ Tue Sep 29, 2009 06:40:52 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |