XRAY - Model racing cars

Yes it worked perfectly. All I done was to run a small amount of super glue between the two mating surfaces and press them together. I went out in the next race and it has not come off since.

Thanks man, I'm gonna try this, hope it works!

ohh, sorry. I thought you ment the screws. tire glue will hold it on there for ever lol

The problem seems to occur sometime's because i needed to fix it just one more time again.

I'm considering to buy a 3racing alu pulley that has it out of one peace:



It's much more practical, and i love things that practically cannot damage...

The 3 Racing alloy pulleys are not one piece, however, the two pieces fit together very tightly. I have been using the 3 Racing alloy pulleys for yonks. I use the 18T at the rear, the 19T on the middle shaft, and use the 27T on the front diff. They work good, but ensure that you use blue loctite on the bolts that go into the front diff. Our track can be quite dirty which can result in the plastic outer edge of the pulleys being destroyed, quickly followed by the belt. The ring of holes in the alloy pulley allow the dirt to be squeezed out. I haven't had any problems since switching to the alloy pulleys. After a while the teeth on the alloy pulleys start to look a bit sharp. However, I haven't bothered replacing them and they still work fine.

Also, I would like to buy an alloy brake pulley as these strip occasionally, but I have not been able to find anybody that sells them. If you find these somewhere, let me know.