XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Chassis Straightness https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=21&t=8403 |
Page 1 of 1 |
Author: | Delboy [ Mon Oct 27, 2008 09:47:14 ] |
Post subject: | Chassis Straightness |
Has any noticed if their chassis (3mm) bends upwards slightly at front and rear - most at rear. |
Author: | meronr [ Wed Oct 29, 2008 04:37:35 ] |
Post subject: | |
Author: | Delboy [ Wed Oct 29, 2008 09:48:37 ] |
Post subject: | |
Author: | jamesrumb [ Wed Oct 29, 2008 18:24:07 ] |
Post subject: | |
Author: | Delboy [ Wed Oct 29, 2008 22:34:29 ] |
Post subject: | |
Author: | rcfoolz [ Fri Oct 31, 2008 03:50:29 ] |
Post subject: | |
Author: | meronr [ Thu Nov 06, 2008 04:20:33 ] |
Post subject: | |
Author: | TP222 [ Tue Dec 23, 2008 08:30:17 ] |
Post subject: | |
Author: | Delboy [ Tue Dec 23, 2008 09:25:49 ] |
Post subject: | |
Author: | TP222 [ Wed Dec 24, 2008 05:43:20 ] |
Post subject: | |
Author: | Martin Hudy [ Fri Jan 02, 2009 16:52:22 ] |
Post subject: | |
every single chassis is checked so for sure you get almost perfectly flat chassis. The chassis can be band mainly after crash. The 3mm chassis can be tweaked easier than 4mm. After you found out that the chassis is tweaked, unscrew little screws from radio deck and from the bulkheads and put the car on the Hudy chassis droop gauge support blocks (#107702) and check if the chassis is flat, if yes tight the screws and check again. If the chassis is tweaked a lot, than take out the chassis from the car and try to make it flat by pushing the chassis on the corner of the table (I hope you understand what I mean). That`s how I tweak my car. |
Author: | Delboy [ Sat Jan 03, 2009 11:43:32 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |