| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| Camber Help ? https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=21&t=8158 |
Page 1 of 1 |
| Author: | trini [ Sat Aug 23, 2008 13:27:44 ] |
| Post subject: | Camber Help ? |
Hi, guys I need some help with my camber, I am running on a low traction technical track when I set Camber link on the inside lower hole of part number 333060 and set camber on hudy tool to 5 the rear cones perfectly. But reading the setup book it says I should not go beyond 3 camber. What would you guys recommend for me to get the recommended 3 degrees? |
|
| Author: | Gordon [ Sat Aug 23, 2008 19:33:45 ] |
| Post subject: | |
you need to read page 32 on the setup manual regarding camber rise. I've had the same issue, and shortening the camber link has worked for me. g |
|
| Author: | trini [ Sat Aug 23, 2008 23:42:29 ] |
| Post subject: | |
When I tried the basic settings which placed the camber link at the Outer Lower hole, the conning was terrible on the outer edges. Should I try playing with the Rear Uprights, it is currently on the base position ? |
|
| Author: | Gordon [ Sun Aug 24, 2008 09:19:31 ] |
| Post subject: | |
| Author: | trini [ Sun Aug 24, 2008 17:13:17 ] |
| Post subject: | |
| Author: | Gordon [ Mon Aug 25, 2008 12:53:01 ] |
| Post subject: | |
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|