XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Correct belt tension https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=21&t=8111 |
Page 1 of 1 |
Author: | hamfri [ Wed Aug 06, 2008 11:33:22 ] |
Post subject: | Correct belt tension |
Author: | ToysRUsKid [ Thu Aug 07, 2008 18:52:47 ] |
Post subject: | |
I think in the manual they show the tensions set in the middle for front/rear. The side belt is left to you. As for what the different settings do, now that's information I haven't seen discussed in the manual or setup book. |
Author: | hamfri [ Fri Aug 08, 2008 14:16:17 ] |
Post subject: | |
Hi ToysRUsKid, I cannot translate exactly your reply into my language. My question was how strong or weak the 3 belts on the NT1 should be tightened. In the meanwhile I had a glance on some technical books and I found out that belts (in real life and perhaps in RC-cars too) are tightened pretty weak. So a belt should bent more or less when tipping on it with a finger. For the rear and front belts I'll propose 5 mm (0.2''). And for the middle belt I propose 10 mm when the tensioner is in contact with. How do you think about? Best regards, Hamfri |
Author: | ToysRUsKid [ Fri Aug 08, 2008 16:24:01 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |