XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
throttle/brake linkage https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=21&t=7559 |
Page 1 of 1 |
Author: | darchard123 [ Thu Apr 24, 2008 22:15:44 ] |
Post subject: | throttle/brake linkage |
how do, just in the process of building my NT1 and i have just started to assamble the brake and throttle linkage! problem i have is the screws that go through the servo arm in to the linkage to do not screw in to the linkage, it looks as though the screw through the servo arm just floats in the opening of the holder attached to the linkage bar! should there not be some ball nuts? I don't have my servo yet so as far as i can see it looks as though the screw attaching the servo to the linkage could come loose! see page 31 of the manual! hope i made sense as its hard to discribe LMK what you think! cheers |
Author: | M.van Lierop [ Thu Apr 24, 2008 23:13:08 ] |
Post subject: | |
Hi, I understand your problem, and I think the manual is wrong because you have to turn the screw form the otherside.. so the screw first through the linkage and then screw it in to the servo arm... But notice that the linkage are still on the under side of the servo arm(same as the pix. in the manual) and do not overtight the screws.. Good luck.. Greetz |
Author: | darchard123 [ Fri Apr 25, 2008 04:37:53 ] |
Post subject: | Thanks |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |