XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
clutch settings https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=21&t=7344 |
Page 1 of 1 |
Author: | tomb [ Mon Mar 24, 2008 09:14:15 ] |
Post subject: | clutch settings |
Here are some clutch setting measurements and data for people to try with their clutches. i've had issues for a while with my clutch but have finally sorted it out with the help of a mate: try the below settings: flyweights: loose type flyweights (non pin mounted style), drilled out to 4mm holes clutch shoe: xray yellow clutch bell: xray ventilated version flywheel: xray lightweight version spring: square spring made by another company thrust bearing: xray, but i was personally using a competitor's version. spring tension: .5mm from end of nut that holds flywheel in place clutch gap shimming: .7mm (shim until bell does not touch shoe, with both bearings installed and then add an extra .1mm shim) endplay: .2mm works awesome now!:cool: these measurements were taken using a digital clutch gap/endplay tool, (not verniers) so measurements are very accurate |
Author: | Favo [ Mon Mar 24, 2008 12:30:17 ] |
Post subject: | |
Hello tomb Would you be able to send me a link on where you brought your digital clutch gap/endplay tool please? If that’s possible or a model name or manufacture so I can goggle it ? Thank you ![]() |
Author: | tomb [ Mon Mar 24, 2008 12:55:21 ] |
Post subject: | |
Author: | Favo [ Tue Mar 25, 2008 11:33:45 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |