XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
pulley Help https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=21&t=7122 |
Page 1 of 1 |
Author: | KWT-NT1 [ Sat Feb 16, 2008 23:25:33 ] |
Post subject: | pulley Help |
Author: | Roelof [ Sat Feb 16, 2008 23:35:45 ] |
Post subject: | |
Author: | KWT-NT1 [ Sat Feb 16, 2008 23:38:55 ] |
Post subject: | |
Author: | rcfoolz [ Sun Feb 17, 2008 09:36:17 ] |
Post subject: | |
The pully could have been damaged by the pipe wire riding on the pully just a bit. If it was not damaged by the pipe support wire, I noticed heavy build-up of gunk at a few tracks that left the car rather dirty. I took the 2 pullies, and drilled each tooth out on both sides with a 1mm drill bit. This allowes the dirt to squish out from the sides keeping the pully from building up dirt |
Author: | _cyclops_ [ Wed Feb 20, 2008 23:33:22 ] |
Post subject: | |
Author: | Danny Izwahyudi [ Thu Feb 21, 2008 04:04:14 ] |
Post subject: | |
what pulley you're running and what tyre size front and rear? |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |